Deutsch
Englisch
Item 1 of 6
1 x Impact anchor/ Drop-in anchor galvanised M10 incl. technical approval
- Approved for anchoring in non-cracked concrete
- Quick and economic fitting
Application:
The drop-in anchor is perfect for fixing climbing holds to non-cracked concrete.
Properties:
- Drop-in anchors suit all screws and thread rods with metric thread
- The low embedment depth reduces the drilling time and provides economic fixing
- After driving repeated removing or fixing is possible as the anchor itself remains in the drill hole
- Electrolytically galvanised
- Approval no. ETA-04/0011 for anchoring in non-cracked concrete
- Approval no. Z-21.1-1745 for anchoring in lightweight ceiling linings
- Fire prevention checked
Principle of Operation:
After setting into the drill hole, the nose of the drop-in anchor is forced apart with a setting tool. Then the climbing hold is screwed into the inside thread.
Instruction for Use:
- Drill a hole
- Clean the drill hole with a brush and/or a blowout shot
- Insert the drop-in anchor to the effective anchoring depth. This is reached when the expanding sleeve doesn't protrude beyond the concrete surface
- By hitting the cone via the setting tool, the anchor is fixed. It is duly set when the setting tool is in contact with the sleeve
- Screw the climbing hold into the thread.(Don't use more torque than allowed according to the table of technical data)
Technical Data:
| M 10 | |
| Drilling depth [mm] (achoring depth, embedment depth) | 44 |
| Drill hole diameter [mm] | 12 |
| Recommended resistance per anchor in non-cracked concrete [kN] incl. partial safety factor | 3.0 |
| Torque when anchoring | 15 |
| Thread diameter [mm] | 10 |