ALPIDEX 500 Zinc-plated T-nuts M10 x 13 x 25 mm for Climbing Holds four pronged T-Nut

ALPIDEX 500 Zinc-plated T-nuts M 10 for Climbing Holds four pronged T-Nut 13 x 25 mm

Packaging unit: 500 T-nuts

You use T-nuts for the fastening of climbing holds on a wooden wall. T-nuts are the counter pieces of hexagon socket screws.

The quality of our T-nuts

Please notice that we only T-nuts weighing 8 g. Many other suppliers offer T-nuts weighing just 6,7 g. These T-nuts can easily turn off.

Features:

• Zinc-plated
• Internal screw thread M 10
• Four points support the torque.
• Cylinder head screw DIN EN ISO 4762 - M10 (DIN 912)
• Countersunk head screw DIN EN ISO 10642 - M10 (DIN 7991 )
• T-nuts are used by furniture making, climbing wall or Boulder wall constructions, for blind and sub-constructions
• Inner area

Technical Data:

Fastening:

First you have to make a raster. Therefore, mark all places where you want to assemble T-nuts. For boulder walls, a hole matrix of 10 cm is advisable (demand/qm: 95 T-nuts). The first row should be displaced to the second row.

You can also use only as many T-Nuts as climbing holds. Then you have only few opportunities to assemble your climbing holds. Furthermore, if you want to expand your climbing wall you`ll have to demount all plates.

After marking all places for your T-nuts, you have to bore 12 mm holes. Then, T-nuts must be installed in the back of your climbing wall. Use a special wood adhesive to give T-nuts a better hold.

If adhesive gets into contact with screw thread you´ll have to clean your T-nut afterward.